Installation Guide

15. Install the Apron Access Panel
IMPORTANT! Risk of product damage. Ensure that the tabs are aligned before pressing the apron panel
into place. Improper alignment can damage the clips.
Ensure that the apron area is free from obstructions.
Position the apron panel in the apron frame.
Slide the apron panel tabs up under the apron frame until the tabs engage and all clips align with
the apron frame opening.
Press the center of the apron panel until it snaps into place.
Repeat for the second apron panel.
Troubleshooting Table
This troubleshooting guide is for general aid only. An Authorized Service Representative or qualified
electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Symptoms Probable Causes Recommended Action
1. Whirlpool does not
start/stop.
A. No power to the pump motor. A. Set/Reset the GFCI breaker. Check
the wiring.
B. Air actuator does not work. B. Replace air actuator. Check air tube
between air actuator and pump.
Replace if necessary.
C. Motor/pump does not work. C. Rebuild or replace motor/pump.
2. Motor starts, but all jets
are not functioning.
A. Jet is closed. A. Rotate jet trim ring
counterclockwise to open.
B. Jet is blocked. B. Remove the blockage.
3. Whirlpool stops
automatically.
A. GFCI trips. A. Identify source of fault, and correct.
B. Suction blocked. B. Remove obstruction.
C. Jets are blocked. C. Remove blockage.
D. Motor overheated and
protection device activated.
D. Check for blockage at motor vents.
Remove blockage and allow motor
to cool.
4. Noisy operation. A. Pump banding straps have not
been cut.
A. Cut pump banding straps with a
pair of tin snips.
5. Leakage is detected under
the whirlpool.
A. Piping leaks. A. Repair any piping leaks.
Clips
Apron Panel
Apron Frame
Tabs
Sterling 21 1070292-2-E