Specification

Technical Information
Fixture*:
Basin area:
Bathing well 46-1/4″ (117.5 cm) x 20-1/2″ (52.1 cm)
Top area 52-1/4″ (132.7 cm) x 22-1/2″ (57.2 cm)
To overflow:
Water depth 11″ (27.9 cm)
Capacity 34 gal (128.7 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Model Door maximum
width
Door maximum
height
76140110
76140120
76240110
76240120
56-3/4″ (144.1 cm) 56-1/2″ (143.5
cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Pump is supplied with a grounding type plug-in cord. Locate
the outlet behind the whirlpool, within 24″ (61 cm) of the
pump.
Do not disassemble the pump or piping as this could void the
warranty.
Size the drain cutout to fit the drain assembly.
Studs should be positioned roughly as shown.
Bath cannot be installed without the wall surround.
The width of the module gets 5/8″ (1.6 cm) narrower at the
back. Furring strips (approximately 1/4″ (6 mm)) should be
used at the back corner studs if drywall will overlap the nailing
flange.
3-1/8" (7.9 cm)
Overflow Detail
4" (10.2 cm)
Drain Cutout
55"
(139.7 cm)
73-1/4"
(186.1 cm)
60"
(152.4 cm)
30"
(76.2 cm)
17"
(43.2 cm)
31-1/4"
(79.4 cm)
6" (15.2 cm)
(Typical)
14" (35.6 cm)
30" (76.2 cm)
16" (40.6 cm) 22-1/4"
(56.5 cm)
59-3/8"
(150.8 cm)
8"
(20.3 cm)
10"
(25.4 cm)
2" (5.1 cm) D.
Drain
3-1/2"
(8.9 cm)
60-1/8" (152.7 cm) Min
60-1/4" (153 cm) Max
31-1/4"
(79.4 cm)
Pump Motor
Location
15-1/4"
(38.7 cm)
8"
(20.3 cm)
1-1/4"
(3.2 cm)
15"
(38.1 cm)
19"
(48.3 cm)
Product Diagram
ACCORD
®
ACCORD
®
60″ (152.4 cm) WHIRLPOOL BATH AND WALL SURROUND
Page2of2
1070292-4-
D