Installation Guide

4. Install the Electrical Outlet
CAUTION: Risk of personal injury. Do not turn on the power until instructed to do so.
Your Sterling whirlpool bath is equipped with a cord and plug. All wiring of the pump and control
has been completed at the factory.
Refer to the label near the pump. This label identifies the electrical rating and model number of the
whirlpool.
Install the GFCI-protected, 120 V, 15 A grounded outlet behind the whirlpool and within 24″ (61 cm)
from the pump’s future location. No other load should be on this circuit.
Install a bonding (grounding) conductor at the future location of the pump in accordance with any
applicable local codes.
Bond in accordance
with applicable codes.
Install a GFCI-protected 120 V,
15 A grounded outlet.
Sterling 9 1032207-2-C