Installation Guide

19. Install the Apron Access Panel
CAUTION: Risk of product damage. Ensure that the tabs are aligned before pressing the apron panel
into place. Improper alignment can damage the clips.
Ensure that the apron area is free from obstructions.
Align the center clip of the access panel with the center slot of the apron frame.
Press the center clip until the apron panel snaps into place.
Slide the apron panel up under the apron frame until the two top clips engage and the apron panel
aligns with the remaining clip positions.
When positioned, press on each of the remaining six clip locations to engage the snap-in clips.
Troubleshooting Table
This troubleshooting guide is for general aid only. An Authorized Service Representative or qualified
electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Symptoms Probable Causes Recommended Action
1. Whirlpool does not start/stop. A. No power to the pump motor. A. Reset the GFCI breaker. Check
the wiring. If the problem
persists, refer to your installer
or dealer.
B. Air actuator does not work. B. Connect, straighten, clean, or
replace air actuator tubing.
Replace the air actuator. Refer
to your installer or dealer.
C. Pump motor does not work. C. Replace the pump motor. Refer
to your installer or dealer.
2. Motor starts, all jets are not
functioning.
A. Jet is closed. A. Rotate the jet trim ring
counterclockwise to open.
B. Jet not installed correctly. B. Reinstall jet; check for O-ring
damage.
C. Jet is blocked. C. Remove the blockage.
3. Whirlpool stops by itself. A. GFCI trips. A. Identify the source of fault and
correct it. If the problem
persists, refer to your installer
or dealer.
B. Suction blocked. B. Remove the obstruction.
C. Jets are blocked. C. Remove the blockage.
Clip
9 Clip Locations
4 Screwdriver Locations
Apron Panel
Center Clip
Apron Frame
1032207-2-C 22 Sterling