Specification

Technical Information
Fixture*:
Basin area:
Bathing well 40″ (1016 mm) x 27″ (686 mm)
Top area 52″ (1321 mm) x 35″ (889 mm)
To overflow:
Water depth 11″ (279 mm)
Capacity 55 gal (208.2 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Model Door width Door maximum
height
76110110
76110120
58-1/2″
(1486 mm)
55-3/4″
(1416 mm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Pump is supplied with a grounding type plug-in cord. Locate
the outlet behind the whirlpool, and within 24″ (610 mm) of
the pump.
Do not disassemble the pump or piping as this could void the
warranty.
Size the drain cutout to fit the drain assembly that will be
used.
End stud positioning is critical.
Studs should be positioned roughly as shown.
3-1/2" (89 mm)
30" (762 mm)
3-1/8" (79 mm)
Overflow Detail
1-1/4"
(32 mm)
43-1/2"
(1105 mm)
27-1/2"
(699 mm)
4"
(102 mm)
8"
(203 mm)
53"
(1346 mm)
73-1/4"
(1861 mm)
3"
(76 mm)
16"
(406 mm)
60"
(1524 mm)
1-1/2"
(38 mm)
19"
(483 mm)
20"
(508 mm)
42"
(1067 mm)
11-1/2"
(292 mm)
16"
(406 mm)
14"
(356 mm)
6" (152 mm)
(Typical)
43-1/2"
(1105 mm)
Drain Cutout
Ø 2" (51 mm)
Drain
8-3/4"
(222 mm)
Pump Motor
Location
60-1/8" (1527 mm) Min
60-1/4" (1530 mm) Max
20-1/4"
(514 mm)
Recommended Support Clip
Location (4 Total)
Product Diagram
ENSEMBLETM
ENSEMBLETM 42″ (1067 mm) WHIRLPOOL BATH AND WALL SURROUND
Page2of2
1016902-4-
L