Use and Care Guide

Technical Information
Fixture*:
Basin area:
Bathing well 40″ (101.6 cm) x 21″ (53.3 cm)
Top area 52″ (132.1 cm) x 29″ (73.7 cm)
To overflow:
Water depth 11″ (27.9 cm)
Capacity 40 gal (151.4 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Pump is supplied with a grounding type plug-in cord. Locate
the outlet behind the whirlpool, and within 24″ (61 cm) of the
pump.
Do not disassemble the pump or piping as this could void the
warranty.
Size the drain cutout to fit the drain assembly that will be
used.
End stud positioning is critical if apron nailing-in flanges are to
be used.
Studs should be positioned roughly as shown.
3" (7.6 cm)
60" (152.4 cm)
1-1/4" (3.2 cm)
16" (40.6 cm)
3-1/2" (8.9 cm)
30" (76.2 cm)
Drain Cutout
3-1/8" (7.9 cm)
Overflow Detail
16" (40.6 cm)
14"
(35.6 cm)
6" (15.2 cm)
(Typical)
Pump Motor
Location
37-1/4"
(94.6 cm)
17-1/4"
(43.8 cm)
8-3/4"
(22.2 cm)
2" (5.1 cm) D.
Drain
8-3/4"
(22.2 cm)
60-1/8" (152.7 cm) Min
60-1/4" (153 cm) Max
4"
(10.2 cm)
8"
(20.3 cm)
24-1/2"
(62.2 cm)
37-1/4"
(94.6 cm)
36"
(91.4 cm)
19"
(48.3 cm)
20"
(50.8 cm)
Product Diagram
ENSEMBLETM
ENSEMBLETM 36″ (91.4 cm) WHIRLPOOL BATH
Page2of2
1021381-4-
G