Dimensions Guide

12-7/8"
Notes
Technical Information
Measure your actual product for rough-in details.
All product dimensions are nominal.
Install this product according to the installation
instructions.
3-Wall AlcoveInstallation:
LeftDrain location:
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
46-1/4" x 20-1/2" (1175 mm x 521 mm)Basin area, bottom:
52-1/4" x 22-1/2" (1327 mm x 572 mm)Basin area, top:
11" (279 mm)Water depth:
Product is designed to be used with a single-hole
mixer valve with an escutcheon cover not to
exceed 7-3/4" (197 mm) in width.
34 gal (128.7 L)Water capacity:
2-3/4" (70 mm)Minimum flat for door:
56-1/2" (1435 mm)Door height required:
Studs should be positioned roughly as shown.
56-3/4" (1441 mm)Door width required:
Double studding is recommended for pivot shower
door installations.
Bath cannot be installed without the wall
surround.
Attach grab bars at the specified backer board
locations only.
Width of back wall at top transitions from 60"
(1524 mm) at the front to 59-3/8" (1508 mm) in
the back corners. Furring strips approximately
1/4" (6 mm) thick should be used at the back
USA/Canada: 1-800-STERLING (1-800-783-7546)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.sterlingplumbing.com.
3-28-2016 03:42
Accord
®
60" x 30" Tile Bath/Shower with AIP Grab Bars
71140113