Installation Guide

Roughing-In
ABCDE F GH
66050100 60″
(152.4 cm)
10″
(25.4 cm)
43-1/2″
(110.5 cm)
21″
(53.3 cm)
18-1/8″
(46 cm)
13″
(33 cm)
29″
(73.7 cm)
41-3/16″
(104.6 cm)
66050101 60″
(152.4 cm)
10″
(25.4 cm)
43-1/2″
(110.5 cm)
21″
(53.3 cm)
18-1/8″
(46 cm)
13″
(33 cm)
29″
(73.7 cm)
41-3/16″
(104.6 cm)
76050100 60″
(152.4 cm)
10″
(25.4 cm)
43-1/2″
(110.5 cm)
21″
(53.3 cm)
18-1/8″
(46 cm)
13″
(33 cm)
29″
(73.7 cm)
41-3/16″
(104.6 cm)
76050101 60″
(152.4 cm)
10″
(25.4 cm)
43-1/2″
(110.5 cm)
21″
(53.3 cm)
18-1/8″
(46 cm)
13″
(33 cm)
29″
(73.7 cm)
41-3/16″
(104.6 cm)
IMPORTANT! Dimensions given in the roughing-in information are critical for proper installation.
Construct the framing and plumbing accurately.
IMPORTANT! All dimensions are nominal. The stud opening tolerance is plus 1/8″ (3 mm) and minus 0.
IMPORTANT! Unless otherwise specified, the floor support under the whirlpool must provide a minimum
of 80 pounds per square foot (390 kilograms per square meter) loading.
NOTE: If a firewall is required, roughing-in dimensions must be increased according to the thickness of
the firewall material. Stud opening dimensions must be measured toward the exposed side of the wall
material.
NOTE: If installing this unit to a masonry wall, make provisions for plumbing connections. Construct a
separate frame wall at least 6″ (15.2 cm) from the masonry wall.
The whirlpool and optional wall surrounds can be installed directly to the framing studs, over wallboard, or
over other water-resistant material. When installing over wallboard or other water-resistant wall material, the
framing dimensions must be increased to accommodate the material thickness.
For whirlpools with wall surrounds, installing accessories that require backing or support is not
14"
(35.6 cm)
14"
(35.6 cm)
8"
(20.3 cm)
2" (5.1 cm) D. Drain
30" (76.2 cm)30" (76.2 cm)
Drain Cutout
Recommended Support Clip or
Roofing Nail Location (5 Total)
Backing Block
Block Locations (3)
When Optional
Apron is Used
4" (10.2 cm)
A
A
F
G
H
C
C
B
B
D
D
E
Diagrams shown are representative and for use with the table only.
Your fixture may appear different from the illustrations.
1016904-2-C 4 Sterling