Specification

Technical Information
Fixture*: basin area top area
Bathing well 42″ (106.7 cm) x
23″ (58.4 cm)
51″ (129.5 cm) x
32-1/2″ (82.6 cm)
To overflow water depth capacity
11-1/4″ (28.6 cm) 56 gal (212 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Pump is supplied with a grounding-type plug-in cord. Locate
the outlet behind the whirlpool, and within 24″ (61 cm) of the
pump.
Pump access opening is required.
Do not disassemble the pump or piping as this could void the
warranty.
Size the drain cutout to fit the drain assembly that will be
used.
End stud positioning is critical if nailing-in flanges are used.
Double studding is recommended for pivot shower door
installations.
Studs should be positioned roughly as shown for support clip
or roofing nail installation.
Backing Block
60" (152.4 cm)
66050100/76050100
60"
(152.4 cm)
42"
(106.7 cm)
18-1/8"
(46 cm)
16-1/2"
(41.9 cm)
43-1/2"
(110.5 cm)
29"
(73.7 cm)
13"
(33 cm)
30-1/2"
(77.5 cm)
29-1/2"
(74.9 cm)
8"
(20.3 cm)
4"
(10.2 cm)
60" (152.4 cm) Min
60-1/8" (152.7 cm) Max
Block Locations (3)
When Optional Apron
is Used
41-3/16"
(104.6 cm)
2" (5.1 cm)
D. Drain
10"
(25.4 cm)
21"
(53.3 cm)
14"
(35.6 cm)
14"
(35.6 cm)
Pump Motor Location
Recommended Support
Clip or Roofing Nail
Location (5 total)
18" (45.7 cm) W
x 15" (38.1 cm) H
Access Panel
Drain
Cutout
1-1/2" (3.8 cm)
4-3/4" (12.1 cm)
Overflow Detail
Product Diagram
TRANQUILITY
®
TRANQUILITY
®
42″ (106.7 cm) OVAL BATH WHIRLPOOL
Page2of2
1016904-4-
G