Installation Guide

7. Assemble the Door Panel
Secure the hinge to the door panel using four of the provided #8-18 x 3/8″ panhead screws.
Install the hinge jamb cap on the top of the hinge jamb where it aligns with edge of door.
Starting on the hinge side of the glass, press the bottom seal onto the bottom of the door panel.
NOTE: Leave a small gap on the handle side of the door for clearance from the strike jamb. The door will
not close properly without this gap.
Assemble, making sure
top edges are flush.
Channel
Hinge
Assembly
#8-18 x 3/8"
Panhead Screw
Door
Panel
Bottom Seal
Hinge
Jam Cap
Hinge
Jam Cap
Channel
Top View
Bottom View
Door Panel Extrusion
Hinge Jamb Cap
1019156-2-F 8 Sterling