Installation Guide

3. Install the Adjustment Clamps
Insert four adjustment clamps into each wall jamb as shown (eight total).
Partially thread a #8-18 x 3/4″ flathead screw through the pre-drilled holes in the wall jambs and
into each adjustment clamp using the 3/32″ hex wrench provided. Do not tighten the screws at this
time.
Adjustment Clamp
#8-18 x 3/4"
Flathead Screw
Note: Do not fully
tighten screw
Wall Jamb
Top View
Top View
Bottom TrackWall Jamb
Sterling 5 1019156-2-F