Installation Guide

12. Install the Handles
Thread the setscrew into the handle with the Sterling logo.
Slide a spacer over the setscrew
Slide the handle assembly through the hole in the glass door, making sure the Sterling logo is facing
the outside of the shower. Do not fully tighten.
Slide the second spacer over the other end of the setscrew. Thread the second handle onto the
setscrew.
Fully tighten both of the handles evenly, making sure the Sterling logo is properly oriented.
13. Caulk the Shower Door
Install the end caps to the tops of the wall jambs. Flat edges are toward the walls.
Apply silicone sealant to the outside of the shower where the wall jambs meet the wall.
Apply sealant to the outside of the shower where the bottom track meets the floor.
Apply sealant to the seam between the bottom track and the wall jamb.
Outside
Handle
Inside
Handle
Handle
Setscrew
Spacer
Hole
Spacer
Wall Jamb
Apply sealant.
End Cap
Bottom View
End Cap
Apply sealant.
Etched Logo
Apply sealant.
Bottom Seal
Inside of
Shower
1019156-2-F 12 Sterling