Instructions / Assembly

If a bulb is not working:

1. First remove the bulb and make sure the wires are on either side of the bulb adaptor so that

they will contact with the brass inside the lamp holders and reinsert.

2. If bulb still does not light, it is blown, remove the bulb and replace only with the supplied

replacement bulbs following the diagram below.

There is a separate instruction sheet enclosed with this assembly instruction, which tells

how to change bulb and fuse, if your tree should not light up.

3. Check fuses in the mini light extension cord and replace if necessary.

STORAGE OF THE TREE:

1. Unplug the cord from the wa

ll outlet or power strip.

2. Gently lift off the tree top and remove the bottom section from the tree stand carefully.

3. Not removing each section by pulling straight out,may result in a bent pole or a disconnected

electric connection in the pole.

4. Gently fold the branches up toward the center.

5. To close the tree stand for storage . Carefully place the tree in its box and tape it shut.

6. Store the tree in a cool, dry location protected from sunlight .

NOTE:

1. DO NOT STORE TREE IN A AREA OR IN AN AREAWHERE THE TEMPERATURE

EXCEEDS 100°F.

2. DO NOT USE A DIMMER SWITCH OR INSTALL ANY ADDITIONAL CHRI

STMAS

LIGHTING OR ORNAMENTATION THAT IS POWERED BY A LIGHT BULB SOCKET.

DOING THIS MAY RESULT IN DAMAGE TO YOUR CHRISTMAS TREE OR CAUSE

PERSONAL INJURY. THIS ACTION WILL RESULT IN A VOID OF THE LIMITED

WARRANTY OF THIS PRODUCT.