Manualshelf

Instructions / Assembly

ManualsBrandsSterling ManualsArtificial Christmas Trees7.5 ft. Indoor Pre-Lit Natural Cut Toledo Pine Artificial Christmas Tree with 800 Clear Lights
12345678
2
Before you start to setup your tree, please read this instruction manual carefully.
WARING –Risk of fire
personal injury and electrical shock.
1. For indoor use only.
2. Do not leave product unattended while plugged in.
3. Replace any missing or broken bulbs before plugging in.
4. Do not place near gas or electric heaters, radiators, fireplaces, candles, outdoor heaters
barbecues or other similar sources of heat.
5.Place on a level, hard, flat surface: do not place where tree is likely to wobble due to uneven
floor or thick carpeting.
6. After assembling the tree and adding decorations, make sure the tree is stable. If tree is
not stable, shift the weight of the decorations, and use support wires to walls or window
frames (make sure they
are secure also).
7. Do not install near fountains, bathtubs, sinks, pools, bath tubs or other wet areas.
8. Do not use candles on the tree.
9. Do not overload extension cords, power strips, or any other power receptacles. Make sure
that the electrical rating of the tree and any other device connected to the same receptacle
is below the maximum rating of the extension cord, power strip or other power receptacle.
10.This is an electrical product-not a toy. To avoid risk of fire, burns, personal injury and
electrical shock it should not be played with or placed where small children and pets can
reach it
.
ASSEMBLY INSTRUCTIONS:
1. Open the tree stand to form an ”X” shape, tighten the eyebolts on the tree stand.
2. The tree stand has a power cord attached, plug this cord into extension cord with foot pedal
switch which is connect outlet or power strip. This will give the power to your stand instantly
making your tree a instant glow power pole tree.
3. The section tags (e.g. SECTION A,B,C or Top) are in alphabetical order from the bottom to
the top of your tree. Please identify sections before assembling.
4. For 2 sections Instant Glow Power Pole - Assemble section B (TOP) with bottom section A.
For 3 sections Instant Glow Power Pole - Insert the middle section B into the bottom section
A and assemble TOP section C with section B. Make sure the pole is firmly inserted.
For 4 sections Instant Glow Power Pole - Insert the section B to the bottom section A; then
assemble section C with the lower section B. Finally, place the top section into the section C.