Dimensions Guide

Backer Board Locations
Notes
Technical Information
Measure your actual product for rough-in details.
All product dimensions are nominal.
Install this product according to the installation
instructions.
3-Wall AlcoveInstallation:
CenterDrain location:
Install this product according to the installation
guide.
Drain cutout in subfloor to be 10-1/2" (267 mm)
per rough-in illustration as shown to allow the
backside of the drain to sit below the subflow
surface.
Studs should be positioned as shown.
Backer boards and fasteners protrude beyond
the back wall 1-1/2" (38 mm). If installing this
product against wall board, 1-1/2" (38 mm) furring
strips installed over the wall board are
recommended. The stud pocket depth of 40-5/8"
(1032 mm) will need to be increased by the
combined thickness of the wall board and furring
strips.
Attach grab bars at the specified backer board
locations only.
1/2" minimum finished floor thickness required.
USA/Canada: 1-800-STERLING (1-800-783-7546)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.sterlingplumbing.com.
11-13-2015 05:25
OC-S-63
63" ADA Shower with Backer Boards
62070106