Dimensions Guide

Installation Notes
Install this product according to the installation guide.
Drain cutout in subfloor to be 10-1/2″ (267 mm) per
roughing-in illustration below to allow the backside of the drain
to sit below the subfloor surface.
Studs should be positioned as shown.
Backer boards and fasteners protrude beyond the back wall
1-1/2″ (38 mm). If installing this product against wall board,
1-1/2″ (38 mm) furring strips installed over the wall board are
recommended. The stud pocket depth of 40-5/8″ (1032 mm)
will need to be increased by the combined thickness of the
wall board and furring strips.
12" (305 mm)
62050125
Ø 3-5/16"
(84 mm)
Drain Hole
4" (102 mm)
Ø 10-1/2"
(267 mm)
Drain Cutout
39-1/2" (1003 mm) Min
39-5/8" (1006 mm) Max
18-3/4"
(476 mm)
13"
(330 mm)
8"
(203 mm)
22"
(559 mm)
32-3/8"
(822 mm)
15"
(381 mm)
19-5/8"
(498 mm)
40-5/8"
(1032 mm) Max
29" (737 mm)
1-1/4"
(32 mm)
39-3/8"
(1000 mm)
39-3/8"
(1000 mm)
8"
(203 mm)
39-3/8"
(1000 mm)
1"
(25 mm)
39-3/8"
(1000 mm)
73-1/4"
(1861 mm)
72"
(1829 mm)
18"
(457 mm)
73-9/16"
(1868 mm)
33"
(838 mm)
Product Diagram
39″ (991 mm) SHOWER BASE AND SURROUND
Page2of2
1016220-4-
G