Installation Guide

3. Install the Lavatory
Concealed Arm Carrier
Install the concealed arm carrier according to the roughing-in
information. Follow the installation information included with the
carrier. Make sure the carrier is level.
Slide the lavatory completely onto the carrier arms. Adjust the
level of the lavatory by turning the front and rear carrier arm
screws in or out as needed. The lavatory should not rock after it
has been leveled.
Carefully tighten the toggle screws until the lavatory is securely
held in place.
Install the faucet and drain according to the manufacturer’s
instructions.
Connect the water supply lines and trap.
Care and Cleaning
Clean the outside surface of your vitreous china lavatory with mild
soap and warm water. Wipe the entire surface completely dry with a
clean, soft cloth. You may use soft abrasive cleaners when necessary to
clean your lavatory. Do not use strong abrasive cleaners, as they will
scratch and dull the surface.
If the surface becomes excessively dirty, use a general purpose cleaner
such as: Fantastik
®
All Purpose, Lysol
®
Basin, Tub and Tile Cleaner,
Turn these screws
to adjust level
Tighten Toggle
Bolts
Arm Carrier Installation
Concealed Arm
Carrier
Sterling 7 1014570-2-E