Installation Guide

6. Install the Bottom Track
Remove the bottom track.
Apply silicone sealant to the underside of the bottom track, as shown.
Make sure the ledge is clean and install the bottom track at the location marked
on the shower ledge.
Use masking tape to hold the bottom track in place.
IMPORTANT! Illustration shows a left side pivot. Reverse the pivot bushing and
plastic plug for a right side pivot.
Insert the plastic plug into the hole on the strike side of the bottom track.
Insert the pivot bushing into the hole on the pivot side of the bottom track.
Installer le rail inférieur
Retirer le rail inférieur.
Appliquer du mastic à la silicone en-dessous du rail inférieur, tel qu’illustré.
S’assurer que le rebord soit propre et installer le rail inférieur à l’emplacement
marqué sur le rebord de la douche.
Utiliser du ruban cache pour maintenir le rail inférieur en place.
IMPORTANT! L’illustration indique un pivot gauche. Inverser la garniture du pivot
et le bouchon en plastic pour un pivot droit.
Insérer le bouchon plastique dans le trou sur le côté de la gâche du rail inférieur.
Dorso del carril inferior
Carril inferior
Dessous du rail inférieur
Rail inférieur
Underside of Bottom Track
Bottom Track
Seal here.
Sceller ici.
Selle aquí.
Lado de contacto
Tapón de plástico
Buje del pivote
Cinta de enmascarar
Lado pivotante
Ruban-cache
Côté butée
Bouchon plastique
Bague du pivot
Côté pivot
Masking Tape
Strike Side
Plastic Plug
Pivot Bushing
Pivot Side
1063213-2-B 12 Sterling