Assembly Instructions

F
D
H
F
D
H
FOOT CAP
Fig. 1
C
B
Page 2
TABLE TOP
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
PARTS LIST DESCRIPTION ORDER PART #
BOLT COVER
HEX BOLT DRIVER
1/4" X 20 MM BOLT
1/4" X 35 MM BOLT
QTY
1
12
8
4
2
1
1
HW0105
HW0006
HW0004
A
B
C
D
E
F
G
H
I
J
LEG CONNECTOR
BRACKET
TABLE LEG
FOOT CAP
FACTORY ASSEMBLY
Ø6.5 X 1.0 MM
WASHER
HW0036
HW0142
8
HW0624
Ø26 X Ø6.5 X 2.0 MM
WASHER
4
1
TOUCH-UP PAINT
G0003
Step 1: Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or
unsure how to proceed with assembly, call our Customer
Service Center at 1-800-416-3511. Do not attempt
assembly if any parts are missing or damaged.
Attach a leg to the leg connector bracket by using the
four 1/4"x20 mm bolts and Ø6.5x1.0 mm washers as
shown in Fig.1. Guide these bolts through the holes in
the leg connector bracket, into the pre-drilled holes in
the legs. Hand tighten only. Repeat for the other leg.
Step 2:
Step 3: With the help of another person, turn the table base
assembly in the upright position. With the help of
another person, carefully place the natural stone table
top onto the table base. After making any necessary
adjustments to the alignment of the table top and the
table base, use a bolt and
washer as shown in Fig. . Guide the bolt through the
hole in the table leg, into the pre-drilled hole on the
underside of the table top. Do not tighten completely.
Repeat on the other side. (Note: holes do not go
through to the top of the table. Holes shown for
illustration purposes only.)
1/4"x 5 mm 26x6.5x2.0 mm
2
3
Step 4: After making any necessary adjustments to the
alignment of the table base and table top, use the hex
bolt driver to tighten all bolts. Note: each bolt must
be tightened a few revolutions at a time. In order to
apply equal pressure to all bolt joints, we recommend
working in a cross corner (X) fashion. Repeat until
all bolts are tight. Do not over tighten. Over
tightening may strip bolts. Cover all bolts with covers.
Step 5: At this time, your table is now ready for use. If you
use the umbrella, please add the umbrella hole
protective ring to the hole in tabletop. If you have any
questions, please call our Customer Service Center
at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames resulting
from over tightened bolts or improper assembly is not covered
under our warranty. Please read all instructions carefully
before assembly. If you have any questions regarding your
assembly, call our Customer Service Center at 1-800-416-3511.
FC0618
UMBRELLA CAP
AND RING SET
FACTORY ASSEMBLY
G0157
Fig.2
A
ALH20017
AT52293
AT52294
AT52295
E
G
H