Instruction Manual

REVISION 9/04 BJF
4
Restart the granulator
TABLE OF CONTENTS
TOPIC/SECTION PAGE
SECTION 2- MACHINE PARTS AND CONTROLS ……………………………………..2-1
2000 Series granulator left front quarter view
2000 Series granulator, right front quarter view ……………………….……………...2-2
2000 Series granulator, machine open front view
2000 Series granulator, left rear quarter view…………………………………….…... 2-3
2000 Series granulator, right rear quarter view
SECTION 3 -INSTALLATION
Overview……………………………………………………………………………… 3-1
Machine weights
Uncrate the granulator
Move the granulator to its work site…………………………………………………...3-2
Allow adequate workspace
Level the granulator
Work safely
Remove the protective coating………………………………………………………...3-3
Check the knives and screens
Power considerations
Electrical wiring ………………………………………………………………………3-4
Work safely
Check for mechanical interferences………………………………………………….. 3-5
Set up the machine functions
Check rotation of motors
Reverse the motor rotation if needed
Interlock switch test procedure………………………………………………………. 3-6
Alternate test for the interlock switches
Lubrication………………………………………………………………………….…3-7
SECTION 4 -SETTINGS AND ADJUSTMENTS
Adjusting or replacing the bed knives………………………………………………... 4-1
Basic facts about the knives
Check all settings and adjustments before granulating any material
Malfunction check
Work safely
Open the cutting chambers interlock…………………………………..…….……...….4-2
Release the cutting chamber fasteners
Open the cutting chamber……………………………………………………………. 4-3
Care in handling knives
Install the rotor-locating pin