User guide

AccuMeter Controller Chapter 13: The Recipe 88
Chapter 13: The Recipe
The AccuMeter blender controller allows a user to specify a recipe much similar to a cooking
recipe that tells the system how much of each material to blend. Typically the recipe is in
percent of overall blend and must add to 100. In some configurations the blender may be broke
down into individual feeders that are not linked by a recipe, but controlled by the same system.
In this case the user would instruct the system on how many lbs/hr or kgs/hr to run out of the
feeder. In this scenario each feeder would have to be started and stopped individually.
Typical recipe page with feeders linked
CHANGING A RECIPE:
• Touch the blue box on the recipe page for the feeder you want to change
• Enter in the new value and hit the enter arrow
• If the recipe is valid then you will be given an “Accept Recipe” button
• The blender will not take the recipe until you hit the “Accept Recipe” button