User guide

AccuMeter Controller Chapter 12: Quick Startup and Calibration 87
Step 5b: Configuring a system to run with all feeders offline
for individual control
(skip this section if you are using the feeders together as
a blender)
• You will first need to enter in “0” values into every feeder’s blue recipe box.
After this hit “Accept Recipe” and you should see the following page:
• Next you will need to touch each feeder to bring up the “feeder popup” page
and set each feeder to “target throughput mode”
• After you do this for each feeder then you can start/stop them by simply
entering in the desired throughput rate for each feeder. This method allows
you to run many independent feeders from the same controller.