User guide

AccuMeter Controller Chapter 12: Quick Startup and Calibration 86
• After entering in a recipe that adds to 100 and is acceptable by the blender you
will be given an “Accept Recipe” button. Touching this button will enter in the
new recipe and will make the button disappear.
• If the blender is either used as a starve feeder or it does not have a central
weigh hopper then you will also need to enter in the target total blend rate here.
• To make the blender start running touch the “on/off” switch. It will visually
illuminate green and will switch positions.
• If you do are using a central non-weighed collection bin then you can also
observe the status of each prox switch by the orange and red indicator here.