User guide

AccuMeter Controller Chapter 11: Configuring a new PLC 63
Step 4: Items on the SETUP DIRECTORY
• Use the UNITS page to change from Metric to Imperial. If this is changed then you
will need to reconfigure all weight settings, recalibrate all loadcells, and recalibrate all
feeders.
• You can also modify the password for the current level that you are logged into by
going under PASSWORDS and then touch “Change Password”.
• Access the DISPLAY CONFIGURATION page to observe the software version in
both the display and the PLC. This page also gives you access to the display’s main
configuration page that will be discussed later in Chapter 6. The DISPLAY VERSION
and the PLC VERSION should always match. If they do not then you will receive
SOFTWARE VERSION CONFLICT message.
• The ALARM LOG can also be accessed to view and print alarms for all feeders.
• When you are finished touch DONE to go back to the main recipe page.