User guide

AccuMeter Controller Chapter 11: Configuring a new PLC 61
• From the ACS ENGINEERING ONLY DIRECTORY touch ENABLE I/O SLOTS
• Open the PLC panel and observe which cards are present. Set each slot that is
present to “ENABLED” by touching the slot’s box. Be sure to use caution while
doing this. If you make a mistake then the PLC will fault and you will need to
reboot the PLC and start this step over. Unlike earlier versions you will not loose
all of the other settings when this happens.
• You should also notice that after you are finished that all of the “OK” lights on the
I/O cards are not solid green and not flashing. Hit done to go back to the ACS
ENGINEERING ONLY page to continue.