User guide

AccuMeter Controller Chapter 11: Configuring a new PLC 59

Chapter 11: Configuring a new PLC

This chapter should be used only if you are either upgrading a blender’s controls from a C2, Covis,

or OL controller. You can also use this chapter as a guide to configuring a new PLC. This chapter

does not cover the actual programming of a blank PLC (that is covered in Chapter 6).

This chapter details every parameter for an AccuMeter system, but assumes that both the Display

and PLC are programmed and communicating.

Step 1: Login to the Controller as the “SUPERVISOR”

• From the main page touch “LOGIN” to bring up the login page

• Touch “User” and enter “SUPERVISOR” and hit enter.

• Touch “Password” and enter “3145348” and hit enter

• Touch the return arrow to complete the login process. You will not receive notification

for success or failure.