User guide

AccuMeter Controller Chapter 9: Programming the display from the Flash Card. 52
You will be prompted with the following screen. You need to click “yes”. If you are tying this
unit into your existing plant network then you must still click yes initially, then you must repeat
this loading process and select “no” the second time. This will allow you to go under the RS
View Communications setup and program the PLC’s device shortcut according to your scheme.
Refer to ACS engineering for more details on this procedure.
After doing this you will need to go to “startup options” and select “Run Current Application”
as mentioned next.
1. Touch “Terminal Settings”