User guide

AccuMeter Controller Chapter 6: Programming a New PLC 43
Chapter 6: Programming a New PLC
Programming the PLC is done by using the PLC PROGRAM CARD compact flash card that
you made in an earlier chapter.
• Locate the card slot on the PLC and insert the PLC PROGRAM CARD as shown
below:
• Next reboot the PLC by turning the power off then on. It is HIGHLY important that
you do not remove the power during this step until the RUN, IO, and OK lights are
SOLID GREEN. The card contains a firmware upgrade in the case the firmware is
different on the CPU you are using. This upgrade can take as long as 5 minutes and if
disturbed will “brick” the CPU and will make it useless to you unless you return it back
to Allen Bradley for repair.
• After you receive solid green lights on the RUN, IO, and OK lights then remove the
carefully remove the card. If you leave the card in it will set the parameters back to
default every time the power is cycled. This will prevent the blender from running
correctly.
• Keep this card in a save location for future use.