User guide

AccuMeter Controller Chapter 5: Programming a New PLCs IP address 40
16. Push the Disable BOOTP-DHCP button. You should get the following Response.
17. IT IS VERY IMPORTANT TO RECEIVE THIS MESSAGE! If you don’t and you close this
Server then the processor will lose its IP address upon power up.
18. If this is not successful then you will see this:
19. If the following error happens, wait one minute, click the OK button and try to disable the BOOTP-
DCHP again. Repeat this till action until the BOOTP-DCHP is disabled. This is very important!