User guide

AccuMeter Controller Chapter 5: Programming a New PLCs IP address 37
5. This will bring up the following window. The following Card is setup to use a DHCP server to get
and IP address. Change it to a Static IP address.
6. Put in the IP address of 192.168.5.1 (if you are using a tying this into your plant network and are
using a different IP subnet then consult your IT department) with the subnet mask of 255.255.255.0
7. Click the Ok button, and then click the Close Button. The IP address is now set.
8. Start the BOOTP-DHCP server by going to Start, All Programs, Rockwell Software, BOOTP-
DHCP Server.