Owner manual
Page vi of 48
6-2-1 Adjusting or Replacing the Bed Knives 23
Upstroke Bed Knife 24
Downstroke Bed Knives 26
6-2-2 Rotor Knife Clearance: 27
6-2-3 Knife Sharpening 29
6.2.3.a. Rotor Knife Sharpening 29
6.2.3.b. Bed Knife Sharpening 29
6-2-4 Drive Belt Tension 30
6-2-5 Lubrication Requirements 31
6-3 Corrective Maintenance 32
6-3-1 Motor Drive Belt Replacement 32
6-3-2 Screen Replacement 33
6-3-3 Pivoting Feed Roll Replacement 34
6-3-4 Rotor and Bearing Replacement 35
7 Troubleshooting 38
7-1 Introduction 38
7-2 Safety 38
7-3 Test Equipment 38
7-4 Locating the Trouble 38
7-5 Troubleshooting Chart 38
7-5-1 Processing Faults 39
7-5-2 Mechanical Faults 40
7-5-3 Electrical Faults 41
8 Spare Parts List 42
9 Appendix 43
10 Contact Information 44