Owner manual
Page 34 of 48
5. Replace the screen, avoiding any hand contact with the rotor
knives, and make sure that the far edge of the screen is
“trapped” beneath the downstroke bed knife block. Tighten the
cradle screws.
6. Check that cutting chamber is clear of any parts or materials.
7. Replace the access panel and tighten the screw on the safety
switch actuator arm to ensure it is activating the switch.
8. Replace the line fuses, unlock the power supply, and turn the
Main Power switch to On.
Figure 11: Screen Replacement
6-3-3 Pivoting Feed Roll Replacement
1. Turn the Main Power switch to Off, lock out the power supply,
and remove the line fuses.
2. Remove the screws on the infeed chute. Remove the feed roll
infeed chute from the machine.
3. Remove the feed roll chain guard on the motor side.
4. Loosen tension on the idler bracket, and remove the chain from
the feed roll sprockets.
5. Remove the wire hex screws and end caps from the end of the
feed roll shafts on the discharge side of the machine.
6. Remove the dowels from the pivot blocks. Remove the
shoulder screw, and then slide the pivot blocks off of the feed
roll shaft.
7. Disconnect the gas springs from the feed roll front frame
NOTE: Caution must be taken when removing or replacing gas
springs. Block the F/R frame in the open position before removing.
Cradle Arm
Screws
Cradle Arms
Screens