Owner manual

Page 33 of 48
3. Loosen the motor base slide mount screws, and turn the
adjusting screws on the motor slide base to release all tension
from the belts (See Figure 10). Remove the belts.
4. Install new belts (refer to the Recommended Spares List on
page 42), and proceed to adjust the belt tension as instructed in
Section 6-2-4 on page 30.
5. Replace the belt guard.
6. Replace the line fuses, unlock the power supply, and turn the
Main Power switch On.
Figure 10: Adjusting the Motor Base
6-3-2 Screen Replacement
1. Turn the Main Power switch to Off, lock out the power supply,
and remove the line fuses.
2. Remove the access panel screws (this includes the safety
switch actuator arm screw) and lift up and out to remove the
access panel. (The panel has a bottom, internal skirt that must
be lifted clear of the base strip.)
3. Remove the cradle arm bolts, and swing the screen cradle arms
down.
4. Remove the screen(s), avoiding contact with the rotor knives.
Belt Guard
Motor Slide Base
Adjusting Screws
Motor Base Slide
Mount Screws
Drive Motor
Motor Slide Base