Owner manual
Page 32 of 48
Rotor Bearings: The flanged piloted rotor bearings are pre-
lubricated and double-sealed, but they should be re-lubricated as
stipulated in Figure 9 on page 32.
Airveying System: This system should be lubricated as indicated in
the literature dealing with the system.
Feed Roll Reductor: The feed roll reductor has been filled with #90
lube oil at assembly, but it should be refilled as stipulated in Figure
9 on page 32.
Tension Idler Sprocket Unit: This unit has been lubricated at
assembly, and it must be re-lubricated as stipulated in Figure 9 on
page 32.
Feed Roll Cartridge Bearings: These bearings have been lubricated
at assembly, and they must be re-lubricated as stipulated in Figure
9 on page 32.
Feed Roll Drive Chain: This is a self-lubricating chain, and it
should be re-lubricated as stipulated in Figure 9 on page 32.
Figure 9: Lubrication Requirements
Lubrication Point Lubricant Frequency
Drive motor Refer to instruction plate on
motor
4 months or 3000 hours
Feed roll reductor #90 Lube oil Refill as needed
Feed roll cartridge bearings Chevron SRI #2
Exxon Andok C
Lidok EP1
2 months or 1500 hours. Grease
when machine is stopped until
small bead appears at bearing
seal, then wipe clean.
Feed roll tension arm idler
sprocket
Chevron SRI #2
Exxon Andok C
Lidok EP1
2 Months or 1500 hours. Grease
when machine is stopped until
small bead appears at nut edge,
then wipe clean.
Feed roll drive chain Molykote Lubricant As required by visual inspection
Rotor bearings Chevron SRI #2
Exxon Andok C
Lidok EP1
2 Months or 1500 hours at 1
oz./bearing.
6-3 Corrective Maintenance
6-3-1 Motor Drive Belt Replacement
To replace the drive belts, proceed as follows:
1. Turn main power switch to Off, lockout power supply, and
remove line fuses.
2. Remove the belt guard to gain access to the belts.