Owner manual

Page 16 of 48
;
Operating and Installation packet
;
Detailed recommended spare parts list
;
Electrical schematic and panel layout drawings
;
Component instruction manuals
Re-inspect the container and packing material to see if you missed
any smaller items during unpacking.
3-4 If the Shipment is Not Correct
If the shipment is not what you ordered, contact the shipping
department immediately. For shipments in the United States and
Canada, call 1 [phone]; for all other countries, call our
international desk at [phone]. Have the order number and
item number available.
Hold the items until you receive shipping instructions.
3-5 Returns
Important!
Do not return any damaged or incorrect items until you receive shipping
instructions from the shipping department.
3-6 Uncrating the Equipment
The complete granulator, including accessory and auxiliary
equipment is packed in a special wooden case for shipment. Refer
to Figure 2 on page 14 for detailed dimensional data and pertinent
weights.
Prepare in advance the site you have selected for installation of the
granulator. Be certain that the area to be occupied by the machine
is clean, level, and free of obstructions. The machine should be set
on a concrete floor, and care must be taken when moving the
machine across a hollow timber floor, so that the low point loading
of the casters does not cause damage. The site you have selected
must have a floor rating to adequately support the weight of the
machine. If necessary, use steel shims under the casters to level the
machine.
If inspection after shipment has revealed no shipping damage,
unpack the unit by removing the polyethylene protective covering
and banding. Remove the envelope with the parts list, assembly