Manual

Mark 96a Sanitary air-Loaded PreSSure reguLator
-3-
mark 96a series Cut-a-Way
Light bias spring for
stable operation at low
flow
Guiding above process
area eliminates
particulate generation
Air loaded for remote
setpoint adjustments
Optimized diaphragm
area for minimal offset
and extended life
Soft sealing for ANSI
Class VI shutoff
No hold up, fully
drainable in this
orientation
available Finishes
Body
• Standard: 20 Ra µin (0,5 Ra µm) (ASME BPE 2009 SF5) mechanical nish and electropolish on inside wet-
ted surfaces; machine nish and electropolish on exterior.
• Optional: 20 Ra µin (0,5 Ra µm) SF5 mechanical nish and electropolish on external surfaces; 8 Ra µin (0,2
Ra µm) nish on internal or external nishes and electropolish (Better than SF4)
Bonnet Dome
• Standard: 20 Ra µin (0,5 Ra µm) machine nished and electropolished 316SST.
If aluminum, not electropolished
• Optional: 20 Ra µin (0,5 Ra µm) mechanical nish and electropolish on external surfaces (SF5). 8 Ra µin (0,2
Ra µm) nish on external surfaces on all sizes and electropolish. (Better than SF4).
If aluminum, not electropolished