Instructions / Assembly

INSTALLATION INSTRUCTIONS

IMPORTANT: StepNpull

will work on any commercial solid

core wood or metal door regardless of the door’s size or

weight. however, if the door is abnormally difﬁcult to pull

open, the door closer resistance should be decreased.

1. StepNpull

should be mounted approximately ⅛" from

the bottom and and outer edge of the door.

2. Mark the holes with a pencil while holding the StepNpull

against the door at a level mounting position. If a metal

kickplate is on the door, drill ¼" holes where marked

before moving onto next step. (Only go through metal

kickplate, not through door).

PAGE 1
INSTALLATION INSTRUCTIONS IMPORTANT: StepNpull® will work on any commercial solid core wood or metal door regardless of the door’s size or weight. however, if the door is abnormally difficult to pull open, the door closer resistance should be decreased. 1. StepNpull® should be mounted approximately ⅛" from the bottom and and outer edge of the door. 2. Mark the holes with a pencil while holding the StepNpull® against the door at a level mounting position.
PAGE 2
3. Wood Doors: Once holes are marked, use provided screws to create a ¼" pilot hole. Use the provided sexed bolt for the middle hole, and the 1 ¼" #12 screws for the outside holes. 4. Metal Doors: Once holes are marked, use provided screws to create a " pilot hole. Use the provided sexed bolt for the middle hole, and the 1 ¼" #12 screws for the outside holes. To prepare the center hole, use a " bit to enlarge the center hole, while drilling through the outer metal skin.