Tractor Interface Module Installation Instructions Switch Input (TIM-SI) 821-7002
Installation Instructions Tractor Interface Module Switch Input (TIM-SI) 821-7002 Getting Started........................................................................................ 1 Installing the TIM...................................................................................... 2 Testing the TIM.. ....................................................................................... 4 On-Board Computer Provider Compatibility....................................................
Installation Instructions Switch Input (TIM-SI) 821-7002 Getting Started The Tractor Interface Module (TIM-SI) is an intuitive device that interfaces between the Trimble on board computer and the BatRF wireless TPMS sensors. It wirelessly receives the tire pressure information transmitted from the BatRF AirBAT TPMS sensors to provide alerts to the driver via the TIM-SI mounted LED light and to remote personnel via email or SMS text messages (if supported by the On Board Computer (OBC) provider).
Installing the TIM-SI 1. Locate the On Board Computer (OBC). TIP – Typical mounting locations for the OBC are: a. Behind or under the passenger seat b. Behind or under the driver’s seat c. For Sleeper Cabs, in the storage area under the bed accessible from the outside of the truck, or in the closet near the bed. 2. Select a Mounting Location for the TIM-SI-SI.
3. Install the TIM-SI-SI In this step, you will use the supplied locking tape to physically mount the TIM-SI unit in the vehicle. Before applying the adhesive side of the tape to a surface, the surface should be free and clear of any oil, dust or other materials. A primer swab is supplied to clean the surface prior to mounting. To open the primer, squeeze the vial at the center where a round dot is located.
Testing TIM– SI Installation the satellite signals (GPS must have view of the sky with no roof overhead). After the test drive, unplug the “+12 VDC Alert” connector found on the left side of the TIM-SI. Wait for about 10 seconds until the Low Tire Alert light has stopped blinking blue and has turned a solid red or the light is off. Plug the cable back in and watch the light blinks.
Certifications FCC (USA) This unit complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID: SRA-821 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
