Owner's Manual

Multi-Device Setup (option 2)
1. Place the device in the desired location in the room.
2. Using an Ethernet cable, connect the device to a network
that supports PoE+. This connection provides the device
with power, data, and other lo T and SIP capabilities.
Note: If your network doesn't support PoE+, you should
purchase a separate PoE+ injector or PoE+ enabled switch.
3. When setting up multiple Stem devices in a room, make
sure you have a Hub. All communications between the
device and the far-end will be done through the Hub, so
no USB connection is needed.
4. You must complete setting up your room via the Stem
ecosystem platform. For more information on setting up
your room, you can visit stemaudio.com/manuals or
stemaudio.com/videos
Note: The ecosystem platform is available on the Stem
Control or in iOS, Windows, and Android apps. You can
also access the platform through your web browser by
typing in the product's IP address. If you need help finding
your IP address press and hold down the Vol+ and Vol- for
5 seconds and the IP address will be read out.
5. That's it! Table is all set up to work within the Stem
ecosystem.