ERST 0 — Dee. 20, 20006 Installation Guide for the Stem co Tassel Interface Module (AIM) The Stem co Asset Interface Module has been designed Toi quick and easy installation & removal. Mo hand tools are required Tor either task, but, the required steps must be followed carefully to ensure success, This proceeding assumes the Snakebite M/T is already installed; 1. LAYOUT PLANNING. Kibitz M/T: The Kibitz M/T must be installed so-the external communication cable canned ion is facing the rear of the trader.
Step A: Attach Retainers (6x) to AIM unit FiG. 1 Place the AIM unit on a flat surface and align sate of the mounting retainers {3 per side) with the attachment rod hole Pass the mounting rod through the assembly as shown. Do this procedure on each side of the unit.
ElG. 2 The mounting rod is secured by the detente and the spring loading provided by the rod, Which is pushed under the screw Bose, as sown. FiG.
Step 2: prepare the attachment surface Fi. 4 Laughably mark the retainer attachment locations (both sides) FG.
FIG. 6 Clean the buffed areas With alcohol pad. Repeat with a fresh pad until no residue is visible on pad. Step 3: Remove tape backing from cache retainer BiG.
Fig. 8 Position the AlN over the desired location as shown while holding the mounting feet up. Minimize laconic between fingers and tape. Place the unit at the desalinated position and the release the feel, allowing them to pivot down and make contact with the mounting surface. Push each foot down firmly against the mounting surface to ensure uniform contact. The tape has instant adhesion, but the bond continues to develop over a period of days.
Step 3: Attach the cable hold-downs (3x): Fig. 8 Typical Cable Retaining Cline, Repeat the buff-and-cleaning operation at each of the designated cable retaining clip locations. The cable should have 3 retainers.
FINAL STEPS: 1. Attach the twist-lock cable connector to the MJT unit. Carefully note the alignment features inside the connector to prevent pin damage. 2. Ensure the cable gland nut on the ATM is tightened. If pliers are used, da not aver-tighten, El.
