Installation Instructions

Configuring the PeopleNET g3 Serial Port
To allow the BarRF TIM to communicate with the PeopleNET g3 services port, the port must be
configured. This is done through the OBC Administration Menu on the display. To configure the
port, follow these steps:
Step 1: From the main menu select
Main and use the down arrow to scroll
through the menu options to the bottom of
the list. Select “OBC Administration” from
the main menu.
Step 2: Using the keyboard enter the
password, “9238”. Then select “Done”.
Step 3: Select “Assign serial port”.
Step 4: Select “g3 Services”. This will
assign the serial port to be used
by g3 Services.
Step 5: Select the baud rate.
The port can be configured to
run at 57,600 baud.
If the serial port assignment has been
changed, the OBC must be reset to make
the change effective.
Step 6: Select “OK” to reset the OBC
and to finish the port configuration.