Installation Instructions

4) Install the cable between the TIM and
the g3 OBC.
Attach the serial port to the 9 pin D
connector of the TIM unit and tighten the
thumb screws. Connect the cable locking
DIN connector to the onboard computer g3
services port (black over-molding) and
tighten. Both power and serial
communications are run through this cable
(eliminates the need for a separate power
cable).
The TIM connects to the PeopleNet On
Board Computer (OBC) via a g3 interface
cable. The g3 Services connection is a
short cable with a black round locking DIN
connector that is provided with the TIM
unit.
5) Connect the 9 pin D cable to the TIM
and tighten the thumb screws
6) Connect the 6 pin round DIN connector
to the BLACK insulated 6 pin DIN
connector that comes out of the breakout
connector of the PeopleNET OBC and
tighten the locking thumb nuts together by
hand.
NOTE- Don’t connect to the RED
or BLUE insulated connectors…it must
be the Black insulated
Connector which is the g3 services
port.
NOTE - Both power and serial
communications are run through this cable
(eliminates the need for a
separate power cable).
To allow the BatRF TIM to communicate
with the PeopleNET g3 services port, the
port must be assigned and configured
using the PeopleNET in cab keyboard and
display.