Installation Instructions

2) Select a mounting location for the
TIM. IMPORTANT – The TIM wirelessly
communicates with the Airbat TPMS
sensors; thus the mounting location must
meet the following requirements:
● DO mount the TIM at window height or
higher in the cab.
● DON’T mount the TIM where metallic
objects are within 1” of the front face next
to the upper right hand corner of the box
(where the receiving antenna is located).
● DON’T mount the TIM within 12 inches of
other wireless transmitters (in-cab WiFi,
Blu-tooth and microwave ovens).
Typically the TIM is mounted above the
passenger door (sleeper cabs) or on the
lower passenger side of the rear window.
TIP – Choose a location that will allow for
easy routing for the cable that runs
between the TIM and the PeopleNET g3
OBC.
4) Install the TIM
Peal the Mushroom head Velcro
adhesive back strip and adhere a piece
to each end of the back of the TIM.
Mount the mating pieces to the TIM
and remove the backing adhesive strip.
Press the TIM into its mounting
location so the adhesive will stick.