User's Manual

12/7/2004 Page 5
To change the pressure warning limits on the Sensor press the right arrow key.
A screen similar to the one shown below will be displayed.
If you want to change the limits, use the arrow keys to navigate to the setting you want to
change then press enter and you will be allowed to change the limits in 5 PSI increments
by once again pressing the up and down arrow keys. When the limits have been set to the
desired values press the enter key which changes the default write settings then arrow
down to the write PSI limits line and press enter. The writing screen will be shown as
portrayed below.
Then you will be returned to the previous screen with a message about whether or not the
write was successful. If the write to the pressure sensor works a screen similar to the one
shown below will be returned.