User's Manual

12/7/2004 Page 12
The unit uses a vertically polarized half wave patch radiator with less than 3 dBi
of gain and less than 20 mW of output power.
FCC conformance statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
FCC ID# SRA-8000000
Part # 800-0000
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
End of User Reference Guide
11/30/2004 3:56:00 PM
Stemco LLC
Should you need any additional assistance with any problems or issues please contact
your STEMCO at [phone], and ask for FIS technical support.
* Do not Copy of distribute without permission from Stemco LLC