Owner's Manual

7
H
G
F
A
ON OFF
1. Put the front cover back on by rst hooking on the top
part, then swivelling the bottom part down.
2. Tighten the screw [A] to secure the front panel.
7
ATTACHING THE FRONT PANEL
4. Then place all the wires in the junction box. Replace the
junction box cover [F] and insert the screw [G] to hold it
in place.
NOTE: If this unit will be controlled by a wall-mounted
thermostat (without an integrated thermostat), use the
switch [H] above the motor to select the desired power.
The required power depends on the size of the room
to be heated and represents approximately 1.25 W per
cubic foot (0.03 per m
3
). The power requirement may
vary depending on a number of factors. See warnings
for more details.
1. Restore power to the fan heater and make sure the fan
heater works by raising the temperature until the unit starts
to heat.
2. See section Using the fan heater, to get the most out of your
unit.
8
TURNING THE POWER BACK ON
WARNING: You must set the wall thermostat to fan heater mode as soon as you restore power. If the thermostat
stays in baseboard mode, the fan heater will run intermittently and may overheat.