User Guide

3
INSSIL20300416
SPECIFICATIONS

VOLTS 240 V
WATTS 1000/2000 W
WEIGHT 12.1 LB / 4.9 KG
DEPTH 4” / 101 MM
WIDTH 13 3/8” / 340 MM
HEIGHT 17 3/8” / 441 MM
INSTALLATION



This heater has been designed for a permanent wall installation in a bathroom, either surface or recess mounted.

1. Make an opening in the wall which is 16 1⁄2’’ (419 mm) high by 11 1⁄2’’ (292 mm) wide.
2. Remove the control knobs (thermostat knob (top) and timer knob (bottom)).
3. Remove the two (2) screws located underneath the unit and take off the front cover by pulling it gently
downwards.
4. Remove the wiring compartment cover (4 screws).
5. Punch out one of the knock outs which allow for cable entry.
6. Insert the unit into the wall opening and secure it in place by screwing four (4) screws into the four (4) holes
on the outer edging of the unit.
7. Make the appropriate electrical connections (red to red; black to black; ground fault protection wire (bare wire)
to ground fault protection screw).
8. Screw back into place the wiring compartment cover.
9. Put the front cover back on.

1- Locate the cable coming from the wall.
2- Remove the control knobs (thermostat knob (top) and timer knob (bottom)).
3- Remove the two (2) screws located underneath the unit and take off the front cover by pulling it gently
downwards.
4- Remove the the wiring compartment cover (4 screws).
5- Punch out one of the knock outs which allow for cable entry.
6- Secure the heater to the wall by inserting screws into the holes at the very back of the heater.
7- Make the appropriate electrical connections (red to red; black to black; ground fault protection wire (bare wire)
to ground fault protection screw).
8- Screw back into place the wiring compartment cover.
9- Put the front cover back on.
TECHNICAL DRAWINGS
9 1/8˝
[232 mm]
8 1/2˝
[216 mm]
1 7/8˝
[47 mm]
12 9/16˝
[319 mm]
10 1/2˝
[266 mm]
16 1/2˝
[419 mm]
11 1/2˝
[292 mm]
2˝
[51 mm]
6 11/16˝
[170 mm]
7/8˝
[22 mm]
KOE Ø
SURFACE
INSTALLATION
RECESSED
INSTALLATION
BACK
BACK
WALL OPENING
FRONT
BOTTOM


SIDE
1"
25mm
1"
25mm
O
7/8"
22mm
KO
1 3/16"
31mm
3 15/16"
101mm
1 1/2"
38mm
13 3/8"
340mm
8"
203mm
17 3/8"
441mm
6 11/16"
170mm
O
7/8"
22mm
KO
11 1/4"
286mm
O
7/8"
22mm
KO
5 5/8"
143mm
15 7/8"
403mm
1 1/16"
26mm
1 1/16"
27mm