User Guide

4
This unit must be connected by a certied electrician. Connect the bare wire
(ground) to the green wire of the unit. Connect wires from the electrical box
to the unit’s supply leads.
N.B. This product must be connected by a qualied electri-
cian, according to the electrical and building codes effective
in your region.
TEMPERATURE CONTROL AND DISPLAY
The thermostat has two modes: the DAY mode, identied on the digital screen by a SUN icon and the NIGHT mode, identied
by a MOON icon. To switch from one mode to the other, simultaneously press down both buttons once.
N.B. When you select the NIGHT mode, the thermostat will respond accordingly for the duration of
the time preprogrammed for this mode (see “Selection of the Duration of the NIGHT Mode”). When the
preprogrammed time has passed, the thermostat will automatically return to the DAY mode.
THE NORMAL DISPLAY WILL CONTINUOUSLY INDICATE:
- the current mode icon (
or );
- the ANTIFREEZE mode icon (
), (if applicable, see “Antifreeze Protection”);
- the LOCK icon (
), (if applicable, see “Lock option”);
- the automatic mode icon (
), (if applicable, see “Automatic Mode”);
- the ambient temperature of the room;
- the selected temperature scale (°C or °F)
Unit
Electric
box
Connector (marette)
Green wire
L1
L2
ELECTRICAL CONNECTION
WITH A BUILT-IN ELECTRONIC THERMOSTAT
OPERATION
MODELS WITH 120 V PLUG
(RESIDENTIAL OUTLET)
THIS UNIT IS EQUIPPED WITH A THREE-WIRE GROUNDING
TYPE AC PLUG:
- For safety reasons, the plug can only be inserted into an outlet
with grounding. If you are unable to insert the plug into the outlet,
contact your electrician to have a suitable receptacle installed. Do
not condemn the ground prong of
the plug.
- This heater must be plugged into
a dedicated 120 V circuit. The
addition of other electrical appli-
ances on this circuit may trip the
circuit breaker.
- Plug the cord of the heater directly
into the wall outlet (do not use an
extension cord).
STANDARD MODELS
(FIXED CONNECTION)
INSTALLATION AND OPERATION
DAY MODE
HOW TO SET THE DAY TEMPERATURE
By pressing down the top or bottom button, you will enter the setting mode
indicated by the ashing SUN icon. This way, you can see the DAY temperature
setting.
You can change the temperature with these same buttons by increasing (top
button) or decreasing (bottom button) the set point. The temperature set point
will increase or decrease by increments of 0.5 °C (or 1 °F) each time you press
down a button. If you hold down the button, the temperature will quickly scroll
through, allowing a faster and more efcient setting.
Once the temperature is set, release the button; normal display will resume after
three (3) seconds.
NIGHT LIGHT MODE
Normally, the backlight is activated when you press down the button, and stays
on for fteen (15) seconds afterwards. To keep the backlight on, simultaneously
press down both buttons for 3 seconds (until the backlight blinks), then release.
Repeat this procedure to deactivate the night light mode.
BUTTON FUNCTIONS
BUTTONS IN DAY MODE IN NIGHT MODE
ONE (1) BUTTON TO SET THE DESIRED TEMPERATURE
TO SET THE DESIRED TEMPERATURE
TWO (2) BUTTONS, SIMULTANEOUSLY TO SWITCH TO NIGHT MODE FOR A PRE-DETERMINED TIME
TO SWITCH BACK TO DAY MODE
TWO (2) BUTTONS, SIMULTANEOUSLY FOR 3 SECONDS TO ACTIVATE OR DEACTIVATE THE BACKLIGHT TO SELECT THE DURATION OF THE NIGHT MODE
TWO (2) BUTTONS, SIMULTANEOUSLY FOR 8 SECONDS TO CHANGE THE TEMPERATURE SCALE (°C OR °F)
N/A
TWO (2) BUTTONS, SIMULTANEOUSLY FOR 13 SECONDS TO ACTIVATE OR DEACTIVATE THE LOCK OPTION
N/A