assembly Instructions
- 12 - - 13 -
LED indication:
SITUATION STATUS
Inclusion / Exclusion The RED LED flashes
slowly.
The device is included After the inclusion / ex-
clusion process or after
initialisation, the RED
LED comes ON once for
1 second.
The device is excluded After the inclusion / ex-
clusion process or after
intitialisation, the RED
LED comes ON once for
10 seconds.
A device in association
group 1 is out of range
The RED LED flashes
slowly with an interval
between flashes.
A device in association
groups 2-4 is out of
range
The RED LED comes ON
for 5 seconds once every
30 seconds.
Poor communication
with Z-Wave module
The RED LED flashes
very rapidly.
The iHF sensor is
deactivated
The BLUE LED is ON.
The firmware is corrupt The BLUE LED flashes
rapidly.
Firmware updating The RED and BLUE LED
flash in alternation.
Note: the current firmware version for the light is
available for downloading from z-wave.steinel.de.
7. Declaration of Conformity
Steinel Vertrieb GmbH hereby declares that the
L 810 LED iHF Z-Wave radio equipment type
conforms to Directive 2014/53/EU. The full wording
of the EU Declaration of Conformity is available for
downloading from the following Internet address:
http://www.steinel.de
8. Functional warranty
This Steinel product has been manufactured with
utmost care, tested for proper operation and safety
and then subjected to random sample inspection.
Steinel guarantees that it is in perfect condition
and proper working order. The warranty period is
36months and starts on the date of sale to the
consumer. We will remedy defects caused by
material flaws or manufacturing faults. The warranty
will be met by repair or replacement of defective
parts at our own discretion. The warranty shall not
cover damage to wear parts, damage or defects
caused by improper treatment or maintenance.
Further consequential damage to other objects shall
be excluded.
Claims under the warranty will only be accepted
if the unit is sent fully assembled and well-packed
with a brief description of the fault, a receipt or
invoice (date of purchase and dealer's stamp) to the
appropriate Service Centre.
Repair service:
If defects occur outside the
warranty period or are not covered
by the warranty, ask your nearest
service station for the possibility
of repair.
9. Technical specifications
Dimensions W x H × D 88 × 230 × 145 mm (L 800 LED iHF)
91 × 230 × 145 mm (L 810 LED iHF)
260 × 230 × 145 mm (L 820 LED iHF)
Material Light enclosure: plastic
Designer trim panel: aluminium
Mains power supply 2 30-240 V, 50 Hz
Output 10 W / 440 lm / 44 lm/W (L 800 LED iHF)
12.5 W / 612 lm / 49 lm/W (L 810 LED iHF)
12.5 W / 612 lm / 49 lm/W (L 820 LED iHF)
Colour temperature 3000 Kelvin (warm white)
LED life expectancy 50,000 hours
Angle of coverage 160° with sneak-by guard
Detection reach 1-5 m (radial) via control dial
Twilight setting 2-2000 lux via control dial and with the app
Time setting 3 min factory setting / 1 s to 15 min with the app
Basic light level 0 or 10%, soft start
Manual override (permanent light) selectable (4 h)
IP rating IP 44
Protection class II
Temperature range - 20°C to + 50°C
Z-Wave wireless range approx. 100 m (unobstructed line of vision)
Radio frequency band 868 MHz
Transmitter power ≤ 2.5 mW
GB