Instructions

16
• Using a voltage, check to make sure
the light is disconnected from the
power supply.
• Make sure power supply remains
interrupted.
Risk of damage to property!
Mixing up connection leads may
produce a short circuit.
• Identify connection leads.
• Re-connect connection leads.
Preparing for installation
• Check all components for damage.
Do not use the product if it is dam-
aged.
• Select an appropriate site to install
the product.
– Take reach into consideration.
(Fig.4.1)
– Take reach and motion detection
into consideration. (Fig.4.2/4.3)
– Vibration-free.
– No obstacles in detection zone.
– Not in explosive atmospheres.
– Not on normally flammable
surfaces.
Mounting procedure
• Check to make sure the power
supply is switched OFF. (Fig.3.8)
• Unscrew locking screw. (Fig.4.4)
• Disconnect light from the wall mount
by pressing the clip. (Fig.4.4)
• Mark drill holes. (Fig.4.5)
• Drill holes (Ø 6 mm) and fit wall plugs.
(Fig.4.6)
• Firmly screw wall mount into place.
(Fig.4.7)
• Connect conductors as shown in the
wiring diagram. (Fig.4.8/3.8)
• Fit light on the wall mount. (Fig.4.9)
• Tighten locking screw. (Fig.4.9)
• Switch ON power supply. (Fig.4.9)
5. Use L 605 S
Factory settings
– Time setting: 5 seconds
– Twilight setting:
daylight mode
– Programme setting:
Programme 1
Time setting (Fig.5.1)
The time (stay-ON time) can be set
to any period from approx. 5seconds to
a maximum of 15minutes. Every move-
ment detected re-activates the light.
Twilight setting (Fig.5.1)
The brightness response threshold
(twilight) can be infinitely varied from
approx. 10 to 2000lux.
–
= daylight mode (depending on
ambient light level)
– = night-time operation (approx.
10lux)
Programme setting (programme 1‑4)
(Fig.5.1)
– With soft light start, light output is
slowly increased to 100% when the
light is switched ON, slowly reduced
when the light is switched OFF.
– Night light is continuous night-time
illumination at approx. 10% light
output. Light is switched to 100%
output when movement is identified
in the detection zone. The light then
switches back to night light.
off
Programme 1
Standard programme
– Soft light start.
– No night light.
1/2
Programme 2
User‑friendly economy
programme
– Soft light start.